Juniper setup client for linux mac os#
Juniper setup client for linux install#

Understanding DHCP Services for EX Series SwitchesВ вЂ“ Juniper. > show system services dhcp > show system services dhcp pool > show system services dhcp binding References To view the various statistics of DHCP server issue any of following commands.

Juniper setup client for linux install#

A user must have administrator privileges to install the PSM client, but does not need administrator privileges to run the client.

Juniper setup client for linux mac os#

Now configure for VLAN 20, # set system services dhcp pool 192.168.2.0/24 # set system services dhcp pool 192.168.2.0/24 address-range low 192.168.2.11 high 192.168.2.20 # set system serivces dhcp pool 192.168.2.0/24 router 192.168.2.1 # set vlan finance l3-interface vlan.20 Use this procedure to install the PSM client on Windows (32-bit or 64-bit), Linux, or MAC OS X. # set unit 0 family ethernet-switching vlan members finance # commit Create Layer 3 interface for both VLANs # set interface vlan unit 10 family inet address 192.168.1.1/24 #set interface vlan unit 20 family inet address 192.168.2.1/24 Configure DHCP Server # set unit 0 family ethernet-switching vlan members marketing Now to make the interfaces ge-0/0/08 and ge-0/0/9 member of its corresponding VLANs hit the following commands: вЂ“ The command will show you the list of VLANs and its interfaces. To view the created VLANs issue the following command, # run show vlans Otherwise you wonвЂ™t be able to see the VLANs by issuing вЂњ show vlansвЂќ command. Issue the commit command after creating VLANs. LetвЂ™s create two VLAns first, vlan 10 as Marketing and vlan 20 as Finance. LetвЂ™s get started by logging into EX3200 switch. We will create two different VLANs and assign ports to each of them. The diagram above represents our network scenario. Configure DHCP Server for Multiple VLANs in JunOS JunOS operating system is different from CIsco IOS.

This is because they all have same operating system i.e. DHCP configuration for Juniper switch and Juniper routers is basically the same. Here we will configure DHCP server for multiple VLANs in JunOS. You can configure DHCP server for oneВ or multiple VLANs. DHCP server can be configured in Juniper EXВ series switches to provide IP addresses to its hosts. The protocol creates database of IP addresses leased to clients. The host use DHCP protocol to obtain IP address from DHCP server. DHCP (Dynamic Host Configuration Protocol)В is a protocol that dynamically provides IP addresses to hosts.